H2009 MRX7 Chassis Kit
Mugen Seiki is pleased to introduce the new generation of the 1/8 on-road racing car MRX7.  Simon Kurzbuch was able to secure the TQ and runner-up title at the EFRA European Championship with the prototype car.  The MRX7 has been fully adapted to the current requirements of the 1/8 on-road category and incorporates a few parts from its successful predecessor.  The team at Mugen Seiki spent a lot of time testing, rethinking existing parts, adjusting the suspension geometry, and improving weight distribution.  The following new features are included in the kit.
Click the picture for larger photo! Click the picture for larger photo! Click the picture for larger photo! Click the picture for larger photo!
Features of the new MRX7 kit (H2009) includes:
Chassis:
- new aluminum chassis with lower motor position and additional side brace to keep strength
- multiple areas to add weight
- slim beautiful lower deck design
- battery back under the fuel tank
- new way to mount the exhaust with possibility to fix super soft in order or reduce vibrations
Bumper:
- new front bumper shape adjusted to current bodyshells
- also available as a harder optional version
Fuel tank:
- new fuel tank to improve engine consistency and maximal size to adjust with volume inserts
Drivetrain:
- all pulleys fixed by screws instead of E-clip to improve reliabilitry
- reduced overall weight with using analuminum gear shaft
- possilility to use the front one-way and rear solid axle in a lower and higher position
- front belt runs in center position
Body mount:
- new lightweight carbon body mount fixed by height adjustable arms using a turnbuckle system
- areas to add additional guides to stiffen lightweight bodyshell's
- new front body post with better position for clip's
Suspension:
- new front suspension geometry to use a narrow track width
- front wheelbase adjustable
- new rear uprights with aluminum inserts possible to adjust in its position
- modern way to mount front dampers
Electronics:
- new lower positioned radio tray reducing COG
Other necessary equipment:
2ch Radio and 2 servos / Receiver / Receiver Battery*1 / Connecting Cable*2 / ST Servo Horn / 21 Class Rear Exhaust Engine / Muffler / Manifold / Manifold Spring / Tire & Wheel  / Air Filter / Engine Starter / Body & Body paint tools / Fuel
Note:
*1: Usable receiver battery size: 88x30.5x17
*2: Require longer battery lead wire 165mm (Including connector).
      An extension connector may be required if the lead length is shorter than 165mm
*The contents are subject to change without notice due to product improvements and specification changes.
*Final production version of product may and will differ from appearance of product shown on this web page.

Copyright © 2025 Mugen Seiki Co., Ltd. All rights reserved.